Test Run & Function Groups Setup

Test Run

To test a function:

  1. Find the required function in the list of functions on the left side of the screen.

  2. Highlight the function.

  3. This will display a description of the function.

  4. Specify a test value for the function's incoming ports.

  5. Click the "Test" button.

  6. As a result of the action, the result of the function will be displayed on the outgoing ports. For example, if you specify numbers in the incoming ports of the sum function, the outgoing port will display the sum of the numbers.

Testing the function

Figure 1. Testing the function

Function Group Setup

To set up a group:

  1. Make sure draft mode is enabled and draft is selected.

  2. Click the "Set groups" button located at the bottom of the function list.

  3. This action will open the "Set up groups" window.

  4. Rename the existing groups, if necessary.

  5. Add a new group if necessary. To do this:

    • Highlight the required nesting level of the groups. Level 1 group is added when you highlight the "Root" group.

    • Click the "Add" button.

    • Enter a name for the group.

  6. Save the changes: press the "Save" button.